联系我们

地址:深圳市龙岗区南湾街道上李朗平吉大道汇富工业区D栋五楼
电话: 13689520514
联系人:姚先生
传真:0755-28301651
邮箱:1392248182@qq.com
企业QQ:1392248182

电金熔金

当前位置:首页 >> 电金熔金
读取中...

  • 产品名称:2KG熔金机


I. Brief

本机采用大功率中频感应加热方法熔炼。既有快速加热又有对金属进行电磁搅拌的功能,以获得温度与成分高度均匀的金属液。

This machine uses the smelting method of HP intermediate frequency induction heating, which can not only quick heat but also conduct the electromagnetic agitation to the metal, for getting the molten metal with highly even temperature and ingredient.

本机操作简单,保养方便,质量可靠,生产安全。既能用于调配黄金合金;又能用于黄金零碎散料。其不仅改变现有人工用气体熔金时产生较强噪音及产生危险性,黄金飞溅,损耗大等现象,同时,中频对人体无害。

This machine has many characteristics like simple operation, convenient maintenance, dependable quality and safe production. It can be used not only in the fragmentary bulk gold as well as in mixing the gold alloy. It changes the phenomenon such as strong noise, risk, gold splashing, big loss and so on when existing artificial gas melts gold, simultaneously, the intermediate frequency is harmless to the body.

 

二:技术参数

II. Technical parameter

电      源        380V/50/60Hz/三相

输出功率      约7.5KW

熔炼金属      黄金、K金、银、铜等

最大容量      2Kg

熔炼时间      2~3分钟

最高温度      1450度

冷却水源      自来水/水冷机

外形尺寸      420×500×850mm

机身重量      50Kg

 

Power Source           380V/50/60Hz/3-phase

Output Power           Approximately 8KW

Smelting metal          Gold, K-gold, silver, copper and etc.

Maximum capacity       2Kg

Smelting time           2~3 minutes

Maximum temperature    1450℃

Cooling water           Running water/water cooling machine

Dimensions             420×500×850mm

Weight                 50Kg

 

 

三:安装

III. Installation

按机箱所示正确连接水、电(如下图)

Connect water and electricity correctly according to the case (shown as in the following figure).


①机箱背面

①Case back

②电源线

②Power cord

③电源空气开关32A

③Air switch 32A

④水龙头

④Tap

⑤水管

⑤Water pipe

⑥入水

⑥Water inlet

⑦出水

⑦Water outlet

⑧排水

⑧Drain

四:操作

IV. Operation

打开电源 > 打开水龙头 > 放熔金杯 > 放料 > 按加热开关 > 按停止开关 > 钳杯倒料

 

Power on  >  Turn on tap  >  Put gold-melting cup > Feed > Press heat switch > Press stop switch >  Empty 

 

 

五:注意事项

V. Precautions

1、在工作时,绝不能断水。

[如意外断水,应立刻把熔金杯拿走,以防把发热圈烧坏]

While working, it is strictly prohibited to cut off the water supply (If the water supply is cut, you should take gold-melting cup away immediately, to prevent the heating ring burning out).

2、熔金机里没有熔金杯不能按加热开关。

Do not press the heat switch if there is no gold-melting cup in the machine.

3、料熔化后,应先按停止开关再倒料出来。

   After melting material, you should press the stop switch and then empty the material.

4、如当天的工作完成了,应把熔金杯拿开,再运转15分钟冷却机器,再关电源、水源。

If completing the intraday work, you should move gold-melting cup away, and run it for 15 minutes to cool machine, turn power source and water source off.

5、当水流指示灯熄灭时,代表缺水或者是水压低,这个时候机器已起保护作用,不能加热。

When the water-flow indicator light extinguishes which represents the water scarcity or low hydraulic pressure the machine acts as the protective function and can not be heated.

6、请用本厂专用熔金杯。

Please use special gold-melting cup of our factory.


电      源        380V/50/60Hz/三相

输出功率      约7.5KW

熔炼金属      黄金、K金、银、铜等

最大容量      2Kg

熔炼时间      2~3分钟

最高温度      1450度

冷却水源      自来水/水冷机

外形尺寸      420×500×850mm

机身重量      50Kg

 

Power Source           380V/50/60Hz/3-phase

Output Power           Approximately 8KW

Smelting metal          Gold, K-gold, silver, copper and etc.

Maximum capacity       2Kg

Smelting time           2~3 minutes

Maximum temperature    1450℃

Cooling water           Running water/water cooling machine

Dimensions             420×500×850mm

Weight                 50Kg